How do I factory reset my APC PDU?

Resetting APC AP7920 PDU

1. Press and hold the reset button for about 10 seconds.
2. The status light should blink rapidly.
3. Release the reset button then press it again for about a second.
4. The light should go orange.
5. After about 20 seconds the reset will complete and the device will have booted.

What is the default password for APC PDU?

what is default password for apc pdu? The default username and password for apc pdu is “apc”. It is a common username and password and can be used for setup and installation of APC Management Card setup, BOOTP and DHCP configuration, Local access to the control console among others.

How do you set up a PDU?

Procedure

1. Connect a DB9-to-RJ45 PDU communications cable from the RS232 port on the PDU to the serial (COM) connector on a monitor.
2. A console window opens.
3. Type the default user ID.
4. When the console prompts you for a password, press Enter.
5. When you are prompted to log in again, type the default user ID Admin .

How do I connect to a PDU?

Connect an Original PDU to a Static IP Address Network

1. Connect a crossover patch cable from the system to the PDU metering unit’s RJ-45 Ethernet port.
2. Connect the PDU power input lead to the AC power source.
3. On the system, use a web browser to log in to the PDU metering unit.

How do I restart PDU?

Reset the PDU Metering Unit (Original PDU)

1. Press and hold the reset button until you see a five-second countdown displayed on the LCD screen.
2. During the five-second countdown, release the reset button and then tap the button again to force the metering unit to reset.

What is the default IP address for apc PDU?

systems, the switched PDUs have the IP address of ‘10.20. 2. x/255.255. 0.0’….Old Firmware.

How do I reset my PDU password?

APC PDU AP7900 – resetting the password

1. Press the reset button for 10 seconds.
2. The light might start pulsing or go out.
3. Release the reset button and press it again for 1 second.
4. The light should pulse / go orange.
5. After a short while (10-20s), the reset will be complete.
6. Now you can login as apc/apc.

How do I access apc PDU?

To access the Web interface and configure the security of your device on the network: 1. Address the Rack PDU by its IP address or DNS name (if configured). 2. Enter the user name and password (by default, apc and apc for an Administrator, or device and apc for a Device Manager).