How do you reset a he3t Kenmore washer?
How do you reset a he3t Kenmore washer?
If you have started a load in your Kenmore Elite HE washer and need to reset it, simply press several buttons on the control panel.
- Press the “Stop” button twice, and then press the “Power” button.
- Choose a wash cycle (e.g. “Normal”), and then choose your wash options (e.g. “Hot/Cold” or “Cold/Cold”).
How do I fix my HE3 Kenmore Elite washer?
Make sure there are no kinks or frozen sections in the hose itself. Plug the washer back in and restart the cycle. An “F02” code indicates a drain problem, so cancel the cycle and unplug the appliance. Check the drain hose for kinks, clogs or frozen sections and restart the washer.
How do you run a diagnostic test on a Kenmore he3t washer?
3 Answers
- With the washer empty, close the door.
- Push “control/on” or “Start”
- Select “Drain/Spin”
- Select “No Spin” by pressing SPIN SPEED touchpad.
- Push “PREWASH” option four times within 5 seconds. (If there is no PREWASH option, press RINSE HOLD 4 times in 5 seconds.)
- C:00 should light up and begin the diagnostic.
What is the capacity of the Kenmore Elite HE3 washer?
The Kenmore Elite HE3 is a 7.2-cubic-foot capacity electric dryer by Kenmore, a household appliance brand sold by Sears.
Why won’t my Kenmore Elite washer turn on?
If the electrical outlet is receiving power, but the washer won’t start, the power cord might be defective. However, this is very rare. To determine if the power cord is defective, use a multimeter to test it for the cord for power. If the power cord is not getting power, replace it.
How do I reset my HE3 washing machine?
You are normally able to reset this type of fault code by pressing the pause/cancel button twice. You can then attempt to drain and spin the clothes by starting a drain/spin cycle. If excessive suds are still present, the washer may reenter the suds kill routine.
Why is my Kenmore Elite washer not draining or spinning?
Most Frequent Causes for Washer won’t drain Sometimes, socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself. Remove the hoses from the pump and check for any obstructions. The lid switch assembly prevents the washer from spinning when the lid is open.
What are the codes for Kenmore Elite washer?
Kenmore HE2 front-load washer error codes
- F01. Main control board EEPROM error. Check/
- F11. Motor control board failure. Check/
- F20. Not filling. Check/
- F21. Will not drain. Check/
- F22. Door lock failure. Check/
- F23. Heating element failure. Check/
- F24. Water temperature sensor error. Check/
- F25. Drive motor tachometer error. Check/
