How do I reset my hunter 44110 thermostat?

You will need to reprogram if you hold the reset button down for 5 seconds and use a small pin or paperclip. If you did that. Press hold twice and hold the temperature until you change it.

What does a flashing 3 mean on a Hunter thermostat?

A flashing 3 means the third setting is currently operating the heater or AC.

How do I reset my hunter digital thermostat?

Press and hold the Programs button, and at the same time press in the recessed Reset button with the tip of a ballpoint pen. Release the Reset button and continue holding the Programs button until the Reset Memory screen appears (then release the Programs button).

Why does my hunter thermostat change by itself?

Solution: Switch out your batteries. It can be as simple as switching out the batteries on your thermostat device. This could also be the reason your screen can go blank sometimes. Thankfully, most thermostats should tell you when the time comes to replace them.

What does a flashing 4 mean on a Hunter thermostat?

4. Indicates if the fan is set to Auto or On modes. 5. Allows you to switch between Heat, Cool, and Off modes.

How do you reset the filter on a Hunter thermostat?

You can reset them all at the same time using the reset button.

1. Open the faceplate on the Hunter thermostat.
2. Twist a paper clip so one of the ends is sticking out.
3. Press the end of the paper clip into the “Reset” pinhole and hold it for two seconds to clear the programming.

Why is the number 4 blinking on my thermostat?

If there is no power to the outdoor unit for an extended period, the YorkGuard will flash a code 4 – Low Discharge Temperature. Check the breaker for the heat pump and make sure that it is not tripped. Watch Video. If the breaker is okay, a qualified service technician should check the system.

How do I stop my thermostat from changing?

What does permanent hold mean on my thermostat?

The temporary hold setting is when you change the temperature setting to a different temperature and it stays at that setting until the next schedule change. The permanent hold setting holds the temperature setting you have chosen for an indefinite time. This overrides your scheduled settings.

How do you fix a blinking thermostat?

Check the Battery If your the screen on your thermostat is blinking, it may just mean that the battery is low, and this is simply your unit’s way of telling you to replace its batteries before it dies entirely. If this is the case, unscrew the thermostat from your wall and replace its batteries.

Why is my thermostat flashing red?

Possible Causes for a Red Flashing Light High Pressure or High Temperature Switch is On. Low Pressure or Low Temperature Switch is On. Low Discharge Temperature. Liquid Line Sensor Failed.

Why is my furnace not blowing hot air?

Troubleshooting Furnaces Not Blowing Hot Air Check batteries of your thermostat and replace the drained or faulty one. Check the fan settings on your thermostat if they are set to “auto” instead of “on”. Make sure someone else has not set your thermostat to a lower temperature.

Why is my thermostat not turning the heat on?

If your heating system will not turn on, the first thing you should do is check the thermostat. The thermostat’s battery may have gone bad, causing it to power off. If your thermostat is hardwired, a power surge, brownout, or brief power outage may have caused the thermostat to lose its settings.

What does it mean when the heat on is flashing on my thermostat?

“Cool On” or “Heat On” is Blinking Then, make sure it’s calling for the right unit to start. This is typically shown by “cool on,” “heat on” or a picture. If this set of words or the illustration is blinking, your thermostat is in a five-minute delay state. This feature stops your equipment from damaging short cycling.